Hyundai Genesis: SRSCM / Front Impact Sensor (FIS) Repair procedures

Removal

• Removal of the airbag must be performed according to the precautions/ procedures described previously. • Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s). • Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.

1.	Disconnect the battery negative cable, and wait for at least three minutes before beginning work.

2.	Remove the radiator assembly. (Refer to Engine Mechanical System - "Radiator")

3.	Disconnect the front impact sensor connector (A), and them loosen the nuts to remove the front impact sensor (B). [Front impact sensor]

Installation

Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.

1.	Install a new front impact sensor.

2.	Tighten the front impact sensor mounting nut. Tightening torque : 8.0 ~ 10.0 N.m (0.82 ~ 1.02 kgf.m, 5.9 ~ 7.4 lb-ft)

3.	Connect the front impact sensor connector.

4.	Install the radiator assembly.

5.	Reconnect the battery negative cable.

6.	After installing the front impact sensor, confirm proper system operation: Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off.

Front Impact Sensor (FIS) Components and Components Location

Components ...

Side Impact Sensor (SIS) Description and Operation

Description The Side Impact Sensor (SIS) system consists of two kinds of side impact sensor which are installed at each center of the front door module (left and right) and two rear sensors whi ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: PGS Unit (Back & Blinde Unit) Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the glove box housing (A). (Refer to Body - "Glove Box") 3. Remove the PGS unit (A) after loosening the nuts. Installation 1. Install the PGS unit. 2. Install the glove box housing. 3. Connector the negati ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Fuel Pressure Sensor (FPS) Troubleshooting

Fail-Safe Mode ItemFail-SafeDuty (%)85     If the fuel pressure sensor malfunctions, it enters fail safe mode. This means that the fuel pressure rises to match the increasing value of the current level and the pressure in the low pressure fuel line remains static desp ...