Hyundai Genesis (DH): Smart Cruise Control System / Smart Cruise Control Unit Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Electrical System / Smart Cruise Control System / Smart Cruise Control Unit Repair procedures

Removal
1.
Remove the bumper.
(Refer to Body - "Front Bumper")
2.
Disconnect the smart cruise control unit connector.
3.
Remove the smart cruise control unit assembly (A) from vehicle after loosening mounting bolts.

Installation
1.
Install in the reverse order of removal.
   
When installing the sensor, align the direction of sensor with the vehicle motion vector and adjust the upside of sensor horizontally using level meter (A).

1.
Align the smart cruise control sensor.
(Refer to "Smart Cruise Control Sensor Alignment")
2.
Install the bumper cover.
(Refer to Body - "Front Bumper Cover")
Smart Cruise Control (SCC) Sensor Alignment
The objective of the alignment is to ensure correct SCC performance. In order for the sensor to perform properly, the sensor must be aligned precisely. The sensor alignment has major impact on road estimation, lane prediction, and target processing. When the sensor is misaligned, the performance of SCC cannot be guaranteed. Therefore, if the sensor needs to be reinstalled or a new sensor to be installed on a vehicle, the sensor shall be aligned by service personnel.
   
The sensor must be aligned when;

    Components 1. SET - switch2. RES + switch3. SCC switch4. CANCEL switch5. CRUISE switch

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Rear Combination Lamp Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. After loosening the nuts (4EA) holding the rear combination lamp and disconnecting the connector (A), remove the outside rear combination lamp assembly. 3. Remove the bulb (A) after turning it in the counter clock-wise direction.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Troubleshooting

    Troubleshooting Problem Symptoms Table Before replacing or repairing air conditioning components, first determine if the malfunction is due to the refrigerant charge, air flow or compressor. Use the table below to help you find the cause of the problem.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0271