Hyundai Genesis (DH): General Information / Components and Components Location
| Components Location |
| Supplemental Restraint System Control Module (SRSCM) |
| Front Impact Sensor (FIS) |
| Side Impact Sensor (SIS) |
| Driver Airbag (DAB) / Passenger Airbag (PAB) / Knee Airbag (KAB) |
| Side Airbag (SAB) |
| Curtain Airbag (CAB) |
| Seat Belt Pretensioner (BPT) |
Component Replacement after Deployment Before doing any SRS repairs, use the GDS to check for DTCs. Refer to the Diagnostic Trouble Code list for repairing of the related DTCs.
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Receiver-Drier Repair procedures
Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with the L wrench (A). Tightening torque : 9.81 ~ 14.71 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft) 3. Remove the receiver-drier (A) from condenser using a long nose plier.
Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Defogging Actuator Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the auto defogging connector. 3. Verify that the auto defogging actuator operates to the open position when connecting 12V to terminal 3 and grounding terminal 4. Verify that the auto defogging actuator operates to the close position when connected in reverse.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Engine Mechanical System
- Engine Electrical System
- Suspension System
- New on site
- Most important about car
