Inspection 1. Disconnect the negative (-) battery terminal. 2. Disconnect the connector (B) after removing the front door frame inner cover (A).
Component Location 1. DDM (Driver door module)2. ADM (Assistant door module)3. Front window motor4. Rear window motor5. Rear window switch
Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with the L wrench (A). Tightening torque : 9.81 ~ 14.71 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft) 3. Remove the receiver-drier (A) from condenser using a long nose plier.
Inspection 1. Press the MODE switch more than 4 times within 2 seconds while pressing the OFF switch. DisplayFail description00Normal51Cluster ion generator fault * For diagnostic procedure, refer to DTC guide. Replacement 1. Disconnect the negative (-) battery terminal.