Hyundai Genesis (DH): Power Windows / Components and Components Location
| Component Location |
| 1. DDM (Driver door module) 2. ADM (Assistant door module) 3. Front window motor | 4. Rear window motor 5. Rear window switch |
Safety Function of Power Window When driver door power window auto-up switch is operated, safety function is activated. 1. Safety function condition When the force of 100N (using the 10N/mm spring) is detected while the window is rising, the window is pulled down.
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Remove the blind spot detection (BSD) switch (A) after disengaging the mounting clip. Installation 1. Install the crash pad side switch assembly after connecting the connector.
Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Defogging Actuator Description and Operation
Description The auto defogging sensor is installed on front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives a signal from the sensor and restrains moisture and eliminates defog by the intake actuator, A/C, auto defogging actuator, blower motor
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Electric Parking Brake (EPB) Repair procedures
- Body (Interior and Exterior)
- Repair procedures
- New on site
- Most important about car
