Hyundai Genesis (DH): Power Windows / Description and Operation

Hyundai Genesis (DH) 2013-2016 Service Manual / Body Electrical System / Power Windows / Description and Operation

Safety Function of Power Window
When driver door power window auto-up switch is operated, safety function is activated.
1.
Safety function condition
When the force of 100N (using the 10N/mm spring) is detected while the window is rising, the window is pulled down.
2.
Length of window reversing (except holding the auto-up switch)
A.
When jamming is detected within the range between 4mm and 250mm from the top of the B pillar the window is pulled down to 300mm from the top of the B pillar.

B.
When jamming is detected within the range of over 250mm from the top of the B pillar the window is pulled down to the lowest position if the total length of jammed object plus 50mm is below the window

    Component Location 1. DDM (Driver door module)2. ADM (Assistant door module)3. Front window motor4. Rear window motor5. Rear window switch

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: License Lamps Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the trunk lid panel. (Refer to Body - "Trunk Lid Back Panel") 3. Remove the license lamp after disengaging the license lamp mounting clip (A) 4. Remove the license lamp assembly after disconnecting the license connector (A).

    Hyundai Genesis (DH) 2013-2016 Service Manual: Console Temperature Control Actuator Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the console temperature control actuator connector. 3. Verify that the console temperature control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0224