Hyundai Genesis: Power Windows / Power Window Motor Repair procedures

Inspection

• Wrap the protective tape on the tool to disassemble with the screwdriver or remover. • Use caution in keeping and handling during disassembling/assembling because it is easily contaminated with lubricant and oil. • Use caution for the crash pad garnish and door trim upper garnish made of timber (Real wood) because they can be scratched or picked. • Be careful not to scratch the door trim and other parts.

1.	Disconnect the negative (-) battery terminal.

2.	Remove the front door trim. (Refer to Body - "Front Door Trim")

3.	Disconnect the connector (A) from the motor.

4.	Connect the terminal No. 2 and No. 3 to battery voltage (12V) and check that the motor operates smoothly when connecting the terminals below.

1.	Disconnect the negative (-) battery terminal.

2.	Remove the rear door trim. (Refer to Body - "Rear Door Trim")

3.	Disconnect the connector (A) from the motor.

4.	Connect the motor terminals No.2 and No.3 directly to battery voltage (12V) and check that the motor operates smoothly. If the operation is abnormal, replace the motor. [Safety]

5.	Connect the motor terminals directly to battery voltage (12V) and check that the motor operates smoothly. Next, reverse the polarity and check that the motor operates smoothly in the reverse direction. If the operation is abnormal, replace the motor. [Standard]

Power Window Motor Schematic Diagrams

Circuit Diagram ...

Power Window Switch Components and Components Location

Components Driver Power Window Switch Assist Power Window Switch Rear Power Window Switch ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Panorama Sunroof Assembly Repair procedures

Removal     • In order to remove the panorama sunroof assembly, use the tools shown in the following figure: [Tooling Diagram] Square wire Insert-type wire grip [Tooling Assembly Diagram] • Insert and affix square wire into the insert hole of the wire grip . ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Height Adjust Repair procedures

Replacement 1. Remove the front seat belt upper anchor. (Refer to Front Seat Belt - "Front Seat Belt Retractor") 2. After loosening the mounting bolts, remove the height adjustor (A). Tightening torque : 39.2 ~ 53.9 N.m (4.0 ~ 5.5kgf.m, 28.9 ~ 39.8 lb-ft) 3. Install in the revers ...