Hyundai Genesis (DH): Driveshaft and axle / Front Propeller Shaft Assembly
- Front Propeller Shaft Components and Components Location
- Front Propeller Shaft Repair procedures
- Propeller Shaft Components and Components Location
- Propeller Shaft Repair procedures
Replacement [LAMMDA] 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wheel and tire from the rear hub.
Components Location 1. Front propeller shaft2. Transfer case3.Front differential assembly
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Refrigerant Line Repair procedures
Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace any faulty tubes or hoses. Cap the open fittings immediately to keep moisture or dirt out of the system. 3. Tighten the bolt or nut joint to the specified torque.
Hyundai Genesis (DH) 2013-2016 Service Manual: Intake Actuator Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 and grounding terminal 4. Verify that the intake actuator operates to the recirculation position when connected in reverse.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Engine Coolant Temperature Sensor (ECTS) Repair procedures
- Smart Cruise Control Unit Repair procedures
- 4 Wheel Drive (AWD) System
- New on site
- Most important about car
