Hyundai Genesis (DH): Front Propeller Shaft Assembly / Front Propeller Shaft Repair procedures

Removal
1.
Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) from the front hub.

   
Be careful not to damage the hub bolts when removing the front wheel and tire.
3.
Remove the under cover (A) & (B).

4.
Remove the cross member (A) by removing bolts.

Tightening torque :
53.9 ~ 63.7 N.m (5.5 ~ 6.5 kgf.m, 39.8 ~ 47.0 lb-ft)

   
When removing the cross member (A), using a jack for safety.
5.
Remove the front propeller shaft by loosening bolts. [Both side]

Tightening torque :
49.0 ~ 68.6 N.m (5.0 ~ 7.0 kgf.m, 36.2 ~ 50.6 lb-ft)

   
1.
When retightening the propeller shaft mounting bolts after removing them, each bolt and washer must be placed in its original position and bolt insertion direction must be the same as before, so make marks not to allow the bolts and washers to be mixed up before removing the propeller shaft.
2.
If the position and direction of the propeller shaft mounting bolts and washers are reversed, it may cause vibration and noise at high vehicle speeds due to imbalance in the propeller shaft.
6.
Install in the reverse order of removal.

    Components Location 1. Front propeller shaft2. Transfer case3.Front differential assembly

    Components Location 1. Propeller shaft2. Center bearing bracket

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: In-car Sensor Description and Operation

    Description An in-car air temperature sensor is located in the crash pad lower panel. The sensor contains a thermistor which measures the temperature of the cabin. The signal determined by the resistance value which changes in accordance with perceived inside temperature, is delivered to the heater control unit and according to this signa

    Hyundai Genesis (DH) 2013-2016 Service Manual: Photo Sensor Description and Operation

    Description The photo sensor is located in the right side of the inside rearview mirror. he integrated rain sensor is located in the right side of the inside rearview mirror. The integrated rain sensor is a multifunctional sensor which combines the photo sensor and auto light sensor, and has a built-in photovoltaic diode (for detecting t

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0309