Hyundai Genesis (DH): ESC(Electronic Stability Control) System / ESC OFF Switch Repair procedures
| Inspection |
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable. |
| 2. |
Remove the crash pad side cover.
(Refer to Body - "Crash Pad") |
| 3. |
Remove the lower panel.
(Refer to Body - "Crash Pad") |
| 4. |
Remove the lower crash pad switch assembly by using the scraper and then disconnect the connectors.
|
| 5. |
Check the continuity between the switch terminals as the ESC OFF switch is engaged.
|
Description 1. The ESC OFF switch is for the user to turn off the ESC system. 2. The ESP OFF lamp is on when ESP OFF switch is engaged.
Description Steering Wheel Angle Sensor detects rotating direction of the vehicle.The rotating direction detected by the sensor is sent to the HECU as CAN signal via CAN communication.
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Heater Unit Components and Components Location
Component Location Components (1) 1. Shower duct (Left)2. Mode actuator (LH)3. Temperature control actuator (LH)4. Temperature door lever (Left)5. Mode actuator (A)6. Console temperature actuator (A)7. Console mode actuator ON/OFF8. Heater case (Left)9.
Hyundai Genesis (DH) 2013-2016 Service Manual: Heater & A/C Control Unit Repair procedures
Self Diagnosis 1. Self-diagnosis process 2. How to read self-diagnostic code After the display panel blinks three times every 0.5 second, the corresponding fault code blinks on the setup temperature display panel every 0.5 second and will show two figures.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Heating, Ventilation and Air Conditioning
- 4 Wheel Drive (AWD) System
- Smart Cruise Control Unit Repair procedures
- New on site
- Most important about car
