Hyundai Genesis (DH): ESC(Electronic Stability Control) System / Steering Angle Sensor Description and Operation

Hyundai Genesis (DH) 2013-2016 Service Manual / Brake System / ESC(Electronic Stability Control) System / Steering Angle Sensor Description and Operation

Description
Steering Wheel Angle Sensor detects rotating direction of the vehicle.The rotating direction detected by the sensor is sent to the HECU as CAN signal via CAN communication.
HECU detects speed of the steering wheel handling and the angle with this CAN signal. HECU also uses this signal as the input signal to control anti-roll.
1.
Disconnect the negative cable from the battery and wait for at least 30 seconds.
2.
Turn the steering wheel so that the front wheels are aligned in a straight line.
3.
Remove the DAB module.
(Refer to Restraint - "Airbag Module")
4.
Disconnect the connector & lock bolt (A) and then remove the steering wheel by using special service tools (09561-11001).
Tightening Torques :
39.2 ~ 49.0N.m (4.0 ~ 5.0 kgf.m, 28.9 ~ 36.2lb-ft)
   
Tighten the lock bolt appropriately and install the SST (09561-1101) in order to remove the steering wheel easily.
   
Do not hammer on the steering wheel to remove it; it may damage the steering column.
When istalling, do not reuse the steering lock bolt.
5.
Remove the steering column shroud.
(Refer to Body - "Steering Column Shroud Panel")
6.
Remove the clock spring.

7.
Install in the reverse order of removal.

    Inspection 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad side cover. (Refer to Body - "Crash Pad") 3.

    Adjustment Calibration (Setting up the zero angle) Steering Wheel Angle Sensor of an absolute angle type (CAN type) measures the angle under the standard of the zero angle set.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Ambient Temperature Sensor Description and Operation

    Description The ambient temperature sensor is located inside the side mirror and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperature, and decrease with higher temperature. The sensor output will be used for discharge temperature control, temperature regulation door control,

    Hyundai Genesis (DH) 2013-2016 Service Manual: Mode Control Actuator Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4. Verify that the mode control actuator operates to the vent mode when connected in reverse.

    Categories

     
    Copyright В© 2025 www.hgenesisdh.com - 0.0469