Hyundai Genesis (DH): Parking Brake System / Electric Parking Brake (EPB) Description and Operation

Hyundai Genesis (DH) 2013-2016 Service Manual / Brake System / Parking Brake System / Electric Parking Brake (EPB) Description and Operation

Description
The EPB is an electronic parking brake.
The EPB is different from existing parking systems which are operated with the brake pedal or the lever type. The EPB system sends the signal to the ECU when a driver operates the EPB switch. The ECU operates the EPB actuator composed of motor and gears. The braking power is generated when the motor pulls the cable connected to the brake system.
The EPB module is one of the parts of EPB system. It monitors the signal of the various sensors in the system, executes a self diagnosis, and controls EPB system with programmed logic.
Main Function
1.
Static Braking Mode
It controls the operation and cancellation condition of the vehicle when the vehicle stops.
(1)
The operation condition: Pull the EPB switch regardless of ignition switch ON / OFF & the brake pedal pressed condition. (Pull).
A.
The Vehicle speed <= 6kph
(2)
The cancellation condition: Push the EPB switch with the ignition switch ON and under the brake pedal pressed condition (Push).
2.
Dynamic Braking Function
DBF (Dynamic Braking Function): The DBF is the braking function which can operate or cancel the EPB system while driving. This function is used when foreign materials get in between the brake pedal or the brake hydraulic line cannot be operated.
(1)
The operation condition
It operates only when the vehicle speed is faster than 6kph and the EPB switch is pushed.
(2)
The cancellation condition: The system is cancelled by not pulling the EPB switch.
(3)
Principle of Operation
A.
ESC system is normal condition: EPB requests applying pressure of brake to ESP system.
B.
ESC system is abnormal condition: EPB operates the parking brake for reduction of speed.
(4)
Special feature
If the anti-lock is operated, the anti-lock control is performed, and the parking lamp on the cluster keeps blinking in case of emergency braking.
3.
DAR(Drive Away Release)
For the driver

    Removal Parking Brake Pedal 1. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 2. Remove the IPM after removing the nut and connector.

    Components 1. EPB2. Bracket No.13. Bracket No.24. EPB Extension wiring harness5. Parking brake cable

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Components and Components Location

    C

    Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Head Lamp Leveling Unit Repair procedures

    Inspection 1. Ignition "ON". 2. Turn on the head lamp switch. 3. Check that the aim of the head lamp changes smoothly when the head lamp leveling device switch is turned on. 4. If it does not operate well, check the connector and terminals to make sure that they are connected.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0227