Hyundai Genesis (DH): Engine Control System / Engine Coolant Temperature Sensor (ECTS) Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Control / Fuel System / Engine Control System / Engine Coolant Temperature Sensor (ECTS) Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the ECTS connector.
3.
Remove the ECTS (Refer to "Removal").
4.
After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECTS terminals 3 and 4.
5.
Check that the resistance is within the specification.
Specification: Refer to

    Description Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Rear Combination Lamp Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. After loosening the nuts (4EA) holding the rear combination lamp and disconnecting the connector (A), remove the outside rear combination lamp assembly. 3. Remove the bulb (A) after turning it in the counter clock-wise direction.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Head Lamp Leveling Unit Troubleshooting

    Inspection with GDS Initialization and diagnosis sequence by using GDS equipment. The following is the summarized A/S procedure. NoProcedure1Park the vehicle on level ground2Tire check3IGN1 ON4Head lamp Low Beam ON5Connection with diagnostic tool6Initial command by diagnostic tool7Clear DTC Code8IGN1 OFF > ON9Re- Connection with diagnostic t

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0291