Hyundai Genesis (DH): Engine Control System / Crankshaft Position Sensor (CKPS) Description and Operation

Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Control / Fuel System / Engine Control System / Crankshaft Position Sensor (CKPS) Description and Operation

Description
Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, the engine may stop because of CKPS signal missing. This sensor is installed on the cylinder block or the transaxle housing and generates alternating current by magnetic flux field which is made by the sensor and the target wheel when engine runs.
The target wheel consists of 58 slots and 2 missing slots on 360 degrees CA (Crank Angle).

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the ECTS connector. 3. Remove the ECTS (Refer to "Removal"). 4. After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECTS terminals 3 and 4.

    Specification ItemSpecificationCoil Resistance (?)500 ~ 620 [25

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Defogging Actuator Description and Operation

    Description The auto defogging sensor is installed on front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives a signal from the sensor and restrains moisture and eliminates defog by the intake actuator, A/C, auto defogging actuator, blower motor

    Hyundai Genesis (DH) 2013-2016 Service Manual: Heater & A/C Control Unit Repair procedures

    Self Diagnosis 1. Self-diagnosis process 2. How to read self-diagnostic code After the display panel blinks three times every 0.5 second, the corresponding fault code blinks on the setup temperature display panel every 0.5 second and will show two figures.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0201