Hyundai Genesis (DH): Heater / Auto Defogging Actuator Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Heating, Ventilation and Air Conditioning / Heater / Auto Defogging Actuator Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the auto defogging connector.
3.
Verify that the auto defogging actuator operates to the open position when connecting 12V to terminal 3 and grounding terminal 4.
Verify that the auto defogging actuator operates to the close position when connected in reverse.

1. -
2. -
3. DEF (Close)
4. Sensor (+ 5V)
5. Feedback signal
6. Sensor ground
7. DEF (Open)

4.
Connect the auto defogging actuator connector.
5.
Turn the ignition switch ON.
6.
Check the voltage between terminals 6 and 5.
Specification
Door position
Voltage (V)
Error detecting
Defog OFF (Close)
1.0

    Description The auto defogging sensor is installed on front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Rheostat Repair procedures

    Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the lower crash pad switch assembly (A) after disengaging the mounting clip. 4. Remove the rheostat switch connector (A).

    Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Indicator Components and Components Location

    C

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0291