Special Service Tools Tool Name / NumberIllustrationDescriptionCrankshaft front oil seal installer09231-3C100Front oil seal mountingCrankshaft pulley fixing tool(09231-1S100)Crankshaft pulley fixed tool handle(09231-2J210)Remove the crankshaft damper pulley and mounting boltsA : 09231-1S100B : 09231-2J210Torque angle adapter09221-4A000Used for tightening torque-to-yield fasteners to a specified angleValve stem seal remover09222-29000Valve stem seal installer09222-2W100Mounting of the valve stem sealsValve spring compressorA : 09222-3K000 (Compressor)B : 09222-3K100 (Holder)Used for removing / installing intake or exhaust valveCrankshaft rear oil seal installerA : 09231-3C200B : 09231-H1100Mounting of the crankshaft rear oil sealOil pan remover09215-3C000Remove the oil pan
Removal and Installation Engine Cover 1. Remove the engine cover (A).
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4. Verify that the mode control actuator operates to the vent mode when connected in reverse.
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 and grounding terminal 4. Verify that the intake actuator operates to the recirculation position when connected in reverse.