| Inspection |
| 1. |
Disconnect the connectors for each motor.
|
| 2. |
When the battery power is supplied to the motor connector, check the motor for smooth operation. |
| 3. |
Reverse the connections and check that the motor turns in reverse. |
| 4. |
If the motor runs abnormally, replace it.
[Driver]
[Assist]
|
| Remove |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the front seat assembly.
(Refer to Body - "Front Seat") |
Description Power seat motor is driven by a motor in the following. 1. Slide motor 2. Front tilt motor 3. Rear Height motor 4. Reclining motor 5.
Inspection 1. Ignition "ON". 2. Turn on the head lamp switch. 3. Check that the aim of the head lamp changes smoothly when the head lamp leveling device switch is turned on. 4. If it does not operate well, check the connector and terminals to make sure that they are connected.
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the glove box housing (A). (Refer to Body - "Glove Box") 3. Remove the PGS unit (A) after loosening the nuts. Installation 1. Install the PGS unit. 2. Install the glove box housing.