Hyundai Genesis (DH): Lubrication System / Oil Pump Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Mechanical System / Lubrication System / Oil Pump Repair procedures

Removal and Installation
1.
Remove the lower oil pan.
(Refer to Lubrication System - "Oil pan")
2.
Remove the upper oil pan.
3.
Remove the bolt (A) and then separate the chain with sprocket from the oil pump.
Tightening torque :
19.6 ~ 24.5 N.m (2.0 ~ 2.5 kgf.m, 14.5 ~ 18.1 lb-ft)

4.
Remove the oil of proportional control solenoid connector (A).

5.
Remove the oil pump bracket bolt (A).

6.
After loosening the oil pump mounting bolt, remove the oil pump (A) and upper oil pan together.
Tightening torque :
20.6 ~ 22.6 N.m (2.1 ~ 2.3 kgf.m, 15.2 ~ 16.6 lb-ft)

7.
To install, reverse the removal procedure.

    Components 1. Oil pump (2WD)2. Oil pump (AWD)3. Oil pump sprocket

    Components 1. Engine oil level gauge2. Engine oil level gauge rod

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Defogging Actuator Description and Operation

    Description The auto defogging sensor is installed on front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives a signal from the sensor and restrains moisture and eliminates defog by the intake actuator, A/C, auto defogging actuator, blower motor

    Hyundai Genesis (DH) 2013-2016 Service Manual: Power Mosfet Repair procedures

    Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and control the voltage of the blower motor. 3. Select the control switch to raise the voltage until high speed. Specification Fan Speed (Manual)Motor Voltage (V)13.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0224