Hyundai Genesis (DH): Hydraulic System / Oil Filter Repair procedures
| Replacement |
| 1. |
Completely drain ATF. |
| 2. |
Remove the valve body cover (A).
|
| 3. |
Oil filter is integral with the valve body cover, so replace the valve body cover.
|
| 4. |
Fill the oil of about 7.0 liters through oil injection hole. |
| 5. |
Check the oil level.
(Refer to Hydraulic system - "Fluid") |
Service Adjustment Procedure Oil level Check The ATF level check is not normally required during scheduled services. If an oil leak is found, perform the oil level check procedure after repairs are completed.
Description The valve body is essential to automatic transmission control and consists of various valves used to control the oil feed from the oil pump.
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Parking Assist Sensor Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the front/rear bumper cover. (Refer to Body - "Front Bumper Cover") (Refer to Body - "Rear Bumper Cover") 3. Disconnect the connector (B) from the parking assist sensor (A).
Hyundai Genesis (DH) 2013-2016 Service Manual: PGS Unit (Back & Blinde Unit) Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the glove box housing (A). (Refer to Body - "Glove Box") 3. Remove the PGS unit (A) after loosening the nuts. Installation 1. Install the PGS unit. 2. Install the glove box housing.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Description and Operation
- Description and Operation
- Brake System
- New on site
- Most important about car
