Hyundai Genesis (DH): Hydraulic System / Fluid Repair procedures
| Service Adjustment Procedure |
| Oil level Check |
The ATF level check is not normally required during scheduled
services. If an oil leak is found, perform the oil level check
procedure after repairs are completed. |
When checking the oil level, be careful not to allow dust, foreign materials, etc. to enter the fill hole.
|
| 1. |
Start the engine. (Don |
Components Location 1. Oil injection hole2. Oil level check plug3. Oil drain plug
Replacement 1. Completely drain ATF. 2. Remove the valve body cover (A). 3. Oil filter is integral with the valve body cover, so replace the valve body cover.
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Description and Operation
Description BSD is a system that measures the speed of and distance from the following vehicles by using two magnetic wave radar sensors attached to the rear bumper, and detects any vehicle within the blind spot zone and gives off alarm (visual and auditory).
Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Defogging Sensor Description and Operation
Description The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives signal from the sensor and restrains moisture and eliminate defog by controlling the intake actuator, A/C, auto defogging actuator,
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Rain Sensor Repair procedures
- Engine Coolant Temperature Sensor (ECTS) Repair procedures
- Brake System
- New on site
- Most important about car
