Hyundai Genesis (DH): Hydraulic System / Valve Body Description and Operation

Hyundai Genesis (DH) 2013-2016 Service Manual / Automatic Transmission System (SBC) / Hydraulic System / Valve Body Description and Operation

Description
The valve body is essential to automatic transmission control and consists of various valves used to control the oil feed from the oil pump. Specifically, these valves consist of pressure regulator valves, oil redirection valves, shift valves, and manual valves. The valve body also features electronic solenoid valves that ensure smooth gear changes.

    Replacement 1. Completely drain ATF. 2. Remove the valve body cover (A). 3. Oil filter is integral with the valve body cover, so replace the valve body cover.

    Components Location 1. Input speed sensor2. Middle speed sensor3. Output speed sensor4. E-Module5. Line pressure control solenoid valve6. Damper clutch control solenoid valve7.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Refrigerant Line Repair procedures

    Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace any faulty tubes or hoses.     Cap the open fittings immediately to keep moisture or dirt out of the system. 3. Tighten the bolt or nut joint to the specified torque.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Compressor Repair procedures

    Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative (-) battery terminal. 3. Remove the engine room cover.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0255