Hyundai Genesis (DH): Automatic Transmission Control System / Underdrive Brake Control Solenoid Valve(UD/B_VFS) Specifications
Hyundai Genesis (DH) 2013-2016 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / Underdrive Brake Control Solenoid Valve(UD/B_VFS) Specifications
| Specifications |
Direct control VFS[UD/C]
? Control type : Normal low type
| Control Pressure kpa (kgf/cm?, psi) | 0~1569.06 (0~16,0~227.57) |
| Current value(mA) | 0~1100 |
| Internal resistance(?) | 5.0~5.6 |
Description UD Clutch control solenoid valve is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the UD Clutch.
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Remove the blind spot detection (BSD) switch (A) after disengaging the mounting clip. Installation 1. Install the crash pad side switch assembly after connecting the connector.
Hyundai Genesis (DH) 2013-2016 Service Manual: Blower Unit Repair procedures
R
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Engine Coolant Temperature Sensor (ECTS) Repair procedures
- Restraint
- Rain Sensor Repair procedures
- New on site
- Most important about car
Copyright В© 2026 www.hgenesisdh.com - 0.0357