| Specification |
| Item | Specification |
| Type | DILKR7A11 |
| Gap | 1.0 ~ 1.1 mm (0.0394 ~ 0.0433 in.) |
Description A spark plug is a device for delivering electric current from an ignition system to the combustion chamber of a spark-ignition engine to ignite the compressed fuel/air mixture therein by means of an electric spark, while containing combustion pressure within the engine.
Inspection [On vehicle inspection] 1. Accelerate the engine to about 3,000 rpm for 3 minutes or longer. 2. Remove the spark plug. 3. Check the spark plug visually.
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the lower crash pad switch assembly (A) after disengaging the mounting clip. 4. Remove the rheostat switch connector (A).
Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative (-) battery terminal. 3. Remove the engine room cover.