Hyundai Genesis (DH): Engine Electrical System / Ignition System
- Description and Operation
- Repair procedures
- Ignition Coil Description and Operation
- Ignition Coil Specifications
- Ignition Coil Schematic Diagrams
- Ignition Coil Repair procedures
- Spark Plug Description and Operation
- Spark Plug Specifications
- Spark Plug Repair procedures
The Micro 570 Analyzer The Micro 570 Analyzer provides the ability to test the charging and starting systems, including the battery, starter and alternator.
Description Ignition timing is controlled by the electronic control ignition timing system. The standard reference ignition timing data for the engine operating conditions are pre-programmed in the memory of the ECM (Engine Control Module).
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Remove the blind spot detection (BSD) switch (A) after disengaging the mounting clip. Installation 1. Install the crash pad side switch assembly after connecting the connector.
Hyundai Genesis (DH) 2013-2016 Service Manual: Refrigerant Line Repair procedures
Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace any faulty tubes or hoses. Cap the open fittings immediately to keep moisture or dirt out of the system. 3. Tighten the bolt or nut joint to the specified torque.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Parking Assist Sensor Repair procedures
- Engine Mechanical System
- Restraint
- New on site
- Most important about car
