| Description |
| 1. |
Slide motor |
| 2. |
Front tilt motor |
| 3. |
Rear Height motor |
| 4. |
Reclining motor |
| 5. |
Cushion extension motor
|
Component Location 1. Slide the motor2. Front Height motor3. Rear height motor4. Backrest adjustment motor5. Cushion extension motor6. Air lumbar support switch7.
Inspection Power Seat Motor 1. Disconnect the connectors for each motor. 2. When the battery power is supplied to the motor connector, check the motor for smooth operation.
Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace any faulty tubes or hoses. Cap the open fittings immediately to keep moisture or dirt out of the system. 3. Tighten the bolt or nut joint to the specified torque.
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4. Verify that the mode control actuator operates to the vent mode when connected in reverse.