Hyundai Genesis (DH): Power Trunk Module / Power Trunk Open/Close Switch Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Body Electrical System / Power Trunk Module / Power Trunk Open/Close Switch Repair procedures

Inspection
1.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
2.
Check for continuity between terminals (A) of the power trunk switch.

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Remove the crash pad lower panel switch (A) after disengaging the mounting clip.

   
Wear gloves to protect hands from injury.
Installation
1.
Install the side crash pad switch assembly.
2.
Install the crash pad lower panel.
3.
Connect the negative (-) battery terminal.

    Components

    Troubleshooting Diagnosis And Testing - Power Trunk Lid System The power trunk lid system is a complex system containing many components. In order to perform accurate testing, or receive outputs the power trunk lid control module must be checked.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Defogging Actuator Description and Operation

    Description The auto defogging sensor is installed on front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives a signal from the sensor and restrains moisture and eliminates defog by the intake actuator, A/C, auto defogging actuator, blower motor

    Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Defogging Actuator Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the auto defogging connector. 3. Verify that the auto defogging actuator operates to the open position when connecting 12V to terminal 3 and grounding terminal 4. Verify that the auto defogging actuator operates to the close position when connected in reverse.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0309