Hyundai Genesis: Power Trunk Module / Power Trunk Module Drive Unit Description and Operation

Hyundai Genesis (DH) 2013-2016 Service Manual / Body Electrical System / Power Trunk Module / Power Trunk Module Drive Unit Description and Operation

Description
1.
Power trunk drive unit(Trunk open)

A.
The trunk open switch operates. (Trunk outside handle switch, Crash pad switch, SMK trunk open button)
B.
The power trunk motor operates and motor gear rotates.
C.
The sector gear rotates.
D.
The drive arm connected to sector gear rotates.
E.
The push rod operates in the direction of the arrow.
F.
The end of the push rod pushes up the trunk.
2.
Power trunk drive unit(Trunk close)

A.
The trunk close switch operates.
B.
The power trunk motor operates and motor gear rotates.
C.
The sector gear rotates.
D.
The drive arm connected to the sector gear rotates.
E.
The push rod operates in the direction of the arrow.
F.
The end of the push rod pushes up the trunk.
Power Trunk Module Drive Unit Schematic Diagrams
Circuit Diagram Block Diagram ...

Power Trunk Module Drive Unit Repair procedures
Removal     1) Put on gloves before removing/installing the drive unit. 2) Do not install or carry a push rod, controller and wire harnesses by holding it with bare hands . ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Main Crash Pad Assembly Repair procedures


Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • When removing the interior trim pieces, use a p ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Components and Components Location


Components Location 1. ECM (Engine Control Module)2. Barometric Pressure Sensor (BPS)3. Intake Air Temperature Sensor (IATS)4. Manifold Absolute Pressure Sensor (MAPS)5. Engine Coolant Temperature Sensor (ECTS)6. Throttle Position Sensor (TPS) [integrated into ETC Module]7. Crankshaft Position ...

© 2013-2023 www.hgenesisdh.com