| Circuit Diagram |

| Block Diagram |

Component Location 1. PTM motor gear2. Sector gear3. Drive arm4. Push rod5. Push rod pin
Description 1. Power trunk drive unit(Trunk open) A. The trunk open switch operates. (Trunk outside handle switch, Crash pad switch, SMK trunk open button) B.
Inspection 1. Ignition "ON". 2. Turn on the head lamp switch. 3. Check that the aim of the head lamp changes smoothly when the head lamp leveling device switch is turned on. 4. If it does not operate well, check the connector and terminals to make sure that they are connected.
Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with the L wrench (A). Tightening torque : 9.81 ~ 14.71 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft) 3. Remove the receiver-drier (A) from condenser using a long nose plier.