| Removal |
| 1. |
Remove the LH/RH cylinder head assembly.
(Refer to Cylinder Head Assembly - "Cylinder Head") |
| 2. |
Remove the water jacket separator 1# (A) and 2# (B).
|
| Installation |
| 1. |
Install the water jacket separator 1# (A) and 2# (B).
|
| 2. |
Install the LH/RH cylinder head.
(Refer to Cylinder Head Assembly - "Cylinder Head") |
Components 1. Water jacket separator 1#2. Water jacket separator 2#3. Cylinder block
Components 1. Drive plate2. Adapter plate3. Crankshaft adapter
C
Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with the L wrench (A). Tightening torque : 9.81 ~ 14.71 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft) 3. Remove the receiver-drier (A) from condenser using a long nose plier.