| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the front/rear bumper cover.
(Refer to Body - "Front Bumper Cover")
(Refer to Body - "Rear Bumper Cover") |
| 3. |
Disconnect the connector (B) from the parking assist sensor (A).
|
| 4. |
Remove the sensor (A) by pulling out both ends of the sensor holder (B).
|
| 5. |
Remove the rear sensor (A) by pulling out both ends of the sensor holder (B).
|
| Installation |
| 1. |
Install the rear ultra sensor after connecting the connector. |
| 2. |
Install the bumper cover. |
| 3. |
Connect the negative (-) battery terminal. |
Description The ambient temperature sensor is located inside the side mirror and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperature, and decrease with higher temperature. The sensor output will be used for discharge temperature control, temperature regulation door control,
Component Location Components (1) 1. Shower duct (Left)2. Mode actuator (LH)3. Temperature control actuator (LH)4. Temperature door lever (Left)5. Mode actuator (A)6. Console temperature actuator (A)7. Console mode actuator ON/OFF8. Heater case (Left)9.