Hyundai Genesis (DH): BCM (Body Control Module) / Specifications
| Specifications |
| Items | Specifications |
| Rated voltage | DC 12V |
| Operating voltage | DC 9 ~ 16V |
| Operating temperature | -30 |
Components NOConnector AConnector BConnector C1Battery +-Room lamp Output2IGN1ECM Mirror +Foot lamp Output3IGN2B CAN High-4ACCB CAN Low-5-PAS (LIN)-6-Integrated sensor (LIN)L_Head lamp washer RLY_OUT7Rear Window Defroster switch-External buzzer output8parking brake switch-SSB light output9PAS off switch-Mood lamp output10Rear curtain switch-Rear curtain motor down Output11sunroof state-Rear curtain motor UP Output12--ATM Solenoid outputs13Trunk open switch-Rear Seat belt light output(RH)14L_NADRI_OPT_INRear Seat belt light output(LH)Rear defogger light output 15L_Deolicated DRI_OPT_INRear Seat belt light output(Center)PAS on light output 16-GND (Power)safety belt light output (Assist)17-? security light output 18-?-19-?-20-?-21-?GND (Rear curtain motor)22-?Rear curtain Power23-??24-??25-??26GND??
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: LKAS Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the mirror wiring cover (A) and rain sensor cover (B). 3. Remove the LKAS unit connector (A). 4. Remove the LKAS unit after disengaging the mounting bracket (A). Installation 1.
Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Defogging Actuator Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the auto defogging connector. 3. Verify that the auto defogging actuator operates to the open position when connecting 12V to terminal 3 and grounding terminal 4. Verify that the auto defogging actuator operates to the close position when connected in reverse.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Suspension System
- Brake System
- ECS-G Sensor Repair procedures
- New on site
- Most important about car
