Hyundai Genesis (DH): Automatic Transmission System / Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission System / Repair procedures

End Of Line(EOL) Input
   
When shift shock occurs or transmission-related parts are replaced, End Of Line(EOL) should be performed.
In the following case, EOL is required.

    Components Location 2WD 1. Engine2. Transmission3. ATF warmer4. Transmission connector(E-Module connector)5. Inhibitor switch6. Shift cable AWD 1.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Unit Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting nuts.     Take care not to separate the bracket from rear bumper when removing the BSD sensor.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Receiver-Drier Repair procedures

    Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with the L wrench (A). Tightening torque : 9.81 ~ 14.71 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft) 3. Remove the receiver-drier (A) from condenser using a long nose plier.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0249