| Inspection |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Open the sunglass case cover from the overhead console and
remove the 2 screws holding the overhead console. Disconnect the switch
connector and Map lamp connector, and then remove the overhead console
lamp (A).
|
| 3. |
Check for continuity between the terminals. If the continuity is not shown as specified, replace the panoramaroof switch.
|
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim assembly. (Refer to Body - "Roof Trim") 3. Remove the panorama sunroof motor (A) after loosening the screws and disconnecting the connector.
Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative (-) battery terminal. 3. Remove the engine room cover.
Component Location Components 1. Seal2. Intake Duct Case3. Intake Door4. Intake Actuator5. Intake Duct Case (A)6. Climate Control Air Filter7. Climate Control Air Filter Cover8. Cluster Ionizer9. Blower Upper Case10. Blower Lower Case11. Power Mosfet12.