Hyundai Genesis (DH): Automatic Transmission Control System / Output Speed Sensor Description and Operation
Hyundai Genesis (DH) 2013-2016 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / Output Speed Sensor Description and Operation
| Description |
The output speed sensor is a vital unit that measures the
rate of rotation of the transmission's turbine shaft and output shaft,
and delivers the readings to the TCM. The sensor provides critical input
data that's used in feedback control, damper clutch control, gear
setting control, line pressure control, clutch activation pressure
control, and sensor fault analysis.
Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal.
Specifications ? Type: Hall Effect Sensor ? Specifications Operation condition (
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Compressor Repair procedures
Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative (-) battery terminal. 3. Remove the engine room cover.
Hyundai Genesis (DH) 2013-2016 Service Manual: Heater Unit Repair procedures
R
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Evaporative Emission Control System
- General Information
- Description and Operation
- New on site
- Most important about car
Copyright В© 2026 www.hgenesisdh.com - 0.027