Hyundai Genesis (DH): Engine Control System / Oil Pressure Sensor (OPS) Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Control / Fuel System / Engine Control System / Oil Pressure Sensor (OPS) Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OPS connector.
3.
Remove the OPS (Refer to "Removal").
4.
After immersing the thermistor of the sensor into engine coolant, measure resistance between the OPS terminals 1 and 2.
5.
Check that the resistance is within the specification.
Specification: Refer to

    Description Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Repair procedures

    Diagnosis With GDS 1. BSD system defects can be quickly diagnosed with the GDS. GDS operates actuator quickly to monitor, input/output value and self diagnosis. 2. Connect the cable of GDS to the data link connector in driver side crash pad lower panel, and turn on the GDS.

    Hyundai Genesis (DH) 2013-2016 Service Manual: PGS Unit (Back & Blinde Unit) Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the glove box housing (A). (Refer to Body - "Glove Box") 3. Remove the PGS unit (A) after loosening the nuts. Installation 1. Install the PGS unit. 2. Install the glove box housing.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0279