Hyundai Genesis (DH): Engine Control System / Accelerator Position Sensor (APS) Description and Operation

Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Control / Fuel System / Engine Control System / Accelerator Position Sensor (APS) Description and Operation

Description
Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine control system, so it consists of the two sensors which adapt individual sensor power and ground line. The second sensor monitors the first sensor and its output voltage is half of the first one. If the ratio of the sensor 1 to 2 is out of the range (approximately 1/2), the diagnostic system judges that it is abnormal.

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the OPS connector. 3. Remove the OPS (Refer to "Removal"). 4. After immersing the thermistor of the sensor into engine coolant, measure resistance between the OPS terminals 1 and 2.

    Specification AcceleratorPositionOutput Voltage (V)APS1APS2C.T0.7 ~ 0.80.33 ~ 0.43W.O.T3.85 ~ 4.351.93 ~ 2.18

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Refrigerant Line Repair procedures

    Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace any faulty tubes or hoses.     Cap the open fittings immediately to keep moisture or dirt out of the system. 3. Tighten the bolt or nut joint to the specified torque.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Console Temperature Control Actuator Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the console temperature control actuator connector. 3. Verify that the console temperature control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0183