Hyundai Genesis (DH): IMS(Integrated Memory System) / Memory power seat unit Components and Components Location

Hyundai Genesis (DH) 2013-2016 Service Manual / Body Electrical System / IMS(Integrated Memory System) / Memory power seat unit Components and Components Location

Components

NO
Connecter A
Connecter B
Connecter C
Connecter D
1
-
B+ (Power)
-
-
2
Cushion extension moter(Front)
GND (Power)
B CAN High
-
3
Front tilt motor(UP)
B+ (Power)
B CAN Low
Slide hall sensor
4
Back motor(Front)
-
-
Tilt hall sensor
5
Slide motor(Front)
GND (Power)
-
Cushion ext hall sensor
6
-
?
-
Sensor VCC
7
Cushion extends motor(Rear)
-
IGN1
8
 Rear height sensor(UP)
-
B+ (ECU)
9
 Rear height sensor(Down)
-
GND (ECU)
10
Front tilt motor(Down)
-
-
11
Back motor(Rear)
-
Recline hall sensor
12
Slide Moter(Rear)
-
Height hall sensor
13
?
-
-
14
-
-
15
-
-
16
-
-
17
-
?
18
-
19
-
20
-

    Description The optimal seat position set by the driver is memorized into the power seat unit by using IMS switch. In case of the position change, the seat can restore its preset position by IMS switch.

    Circuit Diagram

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Rear Combination Lamp Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. After loosening the nuts (4EA) holding the rear combination lamp and disconnecting the connector (A), remove the outside rear combination lamp assembly. 3. Remove the bulb (A) after turning it in the counter clock-wise direction.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Description and Operation

    Description BSD is a system that measures the speed of and distance from the following vehicles by using two magnetic wave radar sensors attached to the rear bumper, and detects any vehicle within the blind spot zone and gives off alarm (visual and auditory).

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0401