Hyundai Genesis (DH): Fuel Delivery System / Fuel Pump Control Module (FPCM) Specifications
| Specification |
| ltem | Specification | |
| Supply Voltage (V) | 8~18 | |
| Supply Current (A) | Max. 10 | |
| Fuel Pressure (kpa) | Starting | 600 |
| Drive | 350 ~ 500 | |
| Stop | 20 Under | |
Description The fuel pump control module (FPCM) is installed on the right side of the trunk compartment. It controls the BLDC (Brushless DC) motor mounted inside the variable low pressure fuel pump.
Circuit Diagram
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Photo Sensor Repair procedures
Inspection 1. Turn the ignition switch ON. 2. Connect the GDS. 3. Emit intensive light toward the photo sensor using a lamp, and check the output voltage change. 4. The voltage will rise with higher intensive light and fall with lower intensive light.
Hyundai Genesis (DH) 2013-2016 Service Manual: Cluster Ionizer Repair procedures
Inspection 1. Press the MODE switch more than 4 times within 2 seconds while pressing the OFF switch. DisplayFail description00Normal51Cluster ion generator fault * For diagnostic procedure, refer to DTC guide. Replacement 1. Disconnect the negative (-) battery terminal.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Components and Components Location
- Body (Interior and Exterior)
- Electric Parking Brake (EPB) Repair procedures
- New on site
- Most important about car
