Hyundai Genesis (DH): Engine Control System / Fuel Pressure Control Valve Description and Operation
Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Control / Fuel System / Engine Control System / Fuel Pressure Control Valve Description and Operation
| Description |
Fuel Pressure Regulator Valve is installed on the high
pressure fuel pump and controls the fuel amount flowing into the
injectors in accordance with the ECM signal calculated based on various
engine condition.
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the VIS valve connector. 3. Measure resistance between the VIS valve terminals 1 and 2.
Specification ItemSpecificationCoil Resistance (?)1.04 ~ 1.27 [23
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: PGS Unit (Back & Blinde Unit) Schematic Diagrams
C
Hyundai Genesis (DH) 2013-2016 Service Manual: Receiver-Drier Repair procedures
Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with the L wrench (A). Tightening torque : 9.81 ~ 14.71 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft) 3. Remove the receiver-drier (A) from condenser using a long nose plier.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Active Air Flap(AAF) Repair procedures
- Parking Assist Sensor Repair procedures
- Body (Interior and Exterior)
- New on site
- Most important about car
Copyright В© 2026 www.hgenesisdh.com - 0.0222