Hyundai Genesis (DH): Engine Control System / Fuel Pressure Control Valve Specifications
| Specification |
| Item | Specification |
| Coil Resistance (?) | 1.04 ~ 1.27 [23 |
Description Fuel Pressure Regulator Valve is installed on the high pressure fuel pump and controls the fuel amount flowing into the injectors in accordance with the ECM signal calculated based on various engine condition.
Signal Waveform Idle rail pressure regulator waveform
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Remove the blind spot detection (BSD) switch (A) after disengaging the mounting clip. Installation 1. Install the crash pad side switch assembly after connecting the connector.
Hyundai Genesis (DH) 2013-2016 Service Manual: Refrigerant Line Repair procedures
Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace any faulty tubes or hoses. Cap the open fittings immediately to keep moisture or dirt out of the system. 3. Tighten the bolt or nut joint to the specified torque.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Active Air Flap(AAF) Repair procedures
- Body Electrical System
- Smart Cruise Control Unit Repair procedures
- New on site
- Most important about car
