Hyundai Genesis (DH): Engine Control System / Variable Intake Solenoid (VIS) Valve Repair procedures
| Inspection |
| 1. |
Turn the ignition switch OFF. |
| 2. |
Disconnect the VIS valve connector. |
| 3. |
Measure resistance between the VIS valve terminals 1 and 2. |
| 4. |
Check that the resistance is within the specification.
Circuit Diagram Description Fuel Pressure Regulator Valve is installed on the high pressure fuel pump and controls the fuel amount flowing into the injectors in accordance with the ECM signal calculated based on various engine condition. Other information:Hyundai Genesis (DH) 2013-2016 Service Manual: Compressor Description and OperationDescription The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low-pressure and low-temperature refrigerant gas into high-pressure and high-temperature refrigerant gas. Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Defogging Actuator Description and OperationDescription The auto defogging sensor is installed on front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives a signal from the sensor and restrains moisture and eliminates defog by the intake actuator, A/C, auto defogging actuator, blower motor Categories
Copyright В© 2026 www.hgenesisdh.com - 0.024
|