Hyundai Genesis (DH): Front Axle Assembly / Front Hub / Knuckle / Tone Wheel Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Driveshaft and axle / Front Axle Assembly / Front Hub / Knuckle / Tone Wheel Repair procedures

Replacement
[4WD]
1.
Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) from the front hub

   
Be careful not to damage the hub bolts when removing the front wheel and tire.
3.
Remove the brake caliper assembly.
(Refer to Brake System - "Front Disc Brake")
4.
Loosen the driveshaft caulking nut (A) and then remove the brake disc by loosening the screw (B-3EA).

Tightening torque
A : 274.6 ~ 294.2 N.m (28.0 ~ 30.0 kgf.m, 202.5 ~ 217.1 lb-ft)
B : 4.9 ~ 5.9 N.m (0.5 ~ 0.6 kgf.m, 3.6 ~ 4.3 lb-ft)

   

    Components 1. Front knuckle assembly2. Dust cover3. Front hub bearing4. Brake disc

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Refrigerant Line Repair procedures

    Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace any faulty tubes or hoses.     Cap the open fittings immediately to keep moisture or dirt out of the system. 3. Tighten the bolt or nut joint to the specified torque.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Power Mosfet Repair procedures

    Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and control the voltage of the blower motor. 3. Select the control switch to raise the voltage until high speed. Specification Fan Speed (Manual)Motor Voltage (V)13.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0261