Hyundai Genesis (DH): Seat Belt Pretensioner / Emergency Fastening Device (EFD) Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Restraint / Seat Belt Pretensioner / Emergency Fastening Device (EFD) Repair procedures

Removal
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the front seat assembly.
(Refer to Body - "Front Seat Assembly")
3.
Remove the front seat outer shield cover.
(Refer to Body - "Front Seat Outer Shield Cover")
4.
Disconnect the EFD system connector.
5.
Unscrew the mounting bolt from the front seat assembly, and then remove the EFD system (A).

Installation
1.
Disconnect the negative (-) cable from battery and wait for at least three minutes.
2.
Install the EFD system with the mounting bolt.
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
3.
Connect the EFD system connector.
4.
Install the front seat shield outer cover.
(Refer to Body - "Front Seat Outer Shield Cover")
5.
Install the front seat assembly.
(Refer to Body - "Front Seat Assembly")
   
Make sure the lock pin is connected in properly.
6.
Reconnect the battery negative cable.
7.
After installing the EFD system, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off.

    Components

    Components 1. Pre-active Seat Belt (PSB)2. Center Pillar 1. Pre-active Seat Belt Unit (PSB)

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Rheostat Repair procedures

    Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the lower crash pad switch assembly (A) after disengaging the mounting clip. 4. Remove the rheostat switch connector (A).

    Hyundai Genesis (DH) 2013-2016 Service Manual: In-car Sensor Repair procedures

    I

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0287