Hyundai Genesis (DH): Cylinder Block / Drive Plate Repair procedures
| Removal and Installation |
| 1. |
Disconnect the battery "-" terminal from the trunk room. |
| 2. |
Remove the automatic transaxle .
(Refer to Automatic Transaxle System - "Automatic Transaxle") |
| 3. |
Remove the adapter plate (B) and the drive plate (A).
|
| 4. |
To install, reverse the removal procedure. |
Components 1. Drive plate2. Adapter plate3. Crankshaft adapter
Components 1. Rear oil seal2. Rear oil seal case
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Defogging Sensor Description and Operation
Description The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives signal from the sensor and restrains moisture and eliminate defog by controlling the intake actuator, A/C, auto defogging actuator,
Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Defogging Actuator Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the auto defogging connector. 3. Verify that the auto defogging actuator operates to the open position when connecting 12V to terminal 3 and grounding terminal 4. Verify that the auto defogging actuator operates to the close position when connected in reverse.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Electric Parking Brake (EPB) Repair procedures
- Rain Sensor Repair procedures
- Front Door
- New on site
- Most important about car
