Hyundai Genesis (DH): Tire Pressure Monitoring System / Description and Operation

Description
Tread Lamp
-
Tire Under Inflation / Leak Warning.

1.
Turn-on condition
A.
When tire pressure is below allowed threshold
B.
When rapid leak is detected by the sensor.
2.
Turn-off condition
A.
Under-inflation ; When tire pressure is above (warning threshold + hysteresis).
B.
Rapid Leak ; When tire pressure is above (leak warning threshold).
Wheel Location
1.
Turn-on condition
A.
At the same time as TREAD Lamp.
B.
Indicates wheel location where under inflation / leak has occurred.
2.
Turn-off condition
A.
At the same time as TREAD Lamp.
   
If wheel locations change in between Ignition cycles, then the system assumes the previous Auto-Located position. Once Auto-Location figures out the position, the correct lamp will be lit.
DTC Warning

1.
Turn-on condition
A.
When the system detects a fault that is external to the receiver / initiator / sensor.
B.
When the system detects a receiver fault.
C.
When the system detects an initiator fault.
D.
When the system detects a sensor fault.
2.
Turn-off condition
A.
If the fault is considered as 'critical', then the lamp is kept on throughout the current Ignition cycle (even if the DTC has been demoted). This is because it is important to bring the problem to the driver

    Components 1. Receiver2. TPMS Sensor (FL) 3. TPMS Sensor (RL) 4. TPMS Sensor (RR)5. TPMS Sensor (FR)

    Description 1. General description WU is a sensor placed in the tire that reports pressure and temperature. The WU is mounted inside the wheels, fixed to the valve.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Description and Operation

    Description BSD is a system that measures the speed of and distance from the following vehicles by using two magnetic wave radar sensors attached to the rear bumper, and detects any vehicle within the blind spot zone and gives off alarm (visual and auditory).

    Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Switch Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Remove the blind spot detection (BSD) switch (A) after disengaging the mounting clip. Installation 1. Install the crash pad side switch assembly after connecting the connector.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0325