Hyundai Genesis (DH): Automatic Transmission System (SBC) / Automatic Transmission Cooling System

Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the under cover. (Refer to Engine Mechanical System - "Engine room under cover") 3.

Description The ATF warmer is mounted on the transmission to reduce oil viscosity frictionby increasing the temperature of oil in cold state, which in turn improves fuel efficiency It is mounted on the entry of the Electronic Throttle Controller (ETC) in series, as shown in the diagram, and minimizes the effects of cabin heating system.

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Light Sensor Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the photo & auto light sensor. (Refer to Windshield Wiper/Washer - "Rain Sensor") Installation 1. Install the auto light sensor. 2. Connect the negative (-) battery terminal.

Hyundai Genesis (DH) 2013-2016 Service Manual: A/C Pressure Transducer Description and Operation

Description The A/C Pressure Transducer (APT) converts the pressure value of high-pressure line into voltage value after measuring it. By converted voltage value, engine ECU controls the cooling fan by operating it at high speed or low speed.

Categories

 
Copyright В© 2026 www.hgenesisdh.com - 0.0272