Hyundai Genesis: Engine And Transaxle Assembly / Engine Cover Repair procedures

Removal and Installation

1.	Remove the engine cover (A). • Lift up the lower end of the engine cover to remove the fixing part, and then alternately remove both the left and right side parts. • When installing, confirm that the mounting rubber insulators has been installed.

2.	To install, reverse the removal procedure.

1.	Remove the engine room cover (A).

2.	To install, reverse the removal procedure.

Engine And Transaxle Assembly

...

Engine Room Under Cover Components and Components Location

Components [2WD] 1. Front under cover2. Rear under cover3. LH side cover4. RH side cover [AWD] 1. Front under cover2. Rear under cover3. LH side cover4. RH side cover ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Engine Mounting Repair procedures

Removal and Installation LH Engine Mounting Insulator 1. Disconnect the negative (-) battery terminal from the trunk room. 2. Remove the engine cover. 3. Remove the engine under cover. 4. Remove the engine room cover and radiator grille upper cover. (Refer to Engine And Transaxle ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Compression Test

Inspection Compression Pressure     In case of lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure. 1. Warm up engine until the normal operating temperature (80~95°C(176-203°F)). 2. Remove the surge tank. (Refer to I ...