Hyundai Genesis (DH): Cylinder Block / Drive Plate Components and Components Location
| Components |
| 1. Drive plate 2. Adapter plate | 3. Crankshaft adapter |
Removal 1. Remove the LH/RH cylinder head assembly. (Refer to Cylinder Head Assembly - "Cylinder Head") 2. Remove the water jacket separator 1# (A) and 2# (B).
Removal and Installation 1. Disconnect the battery "-" terminal from the trunk room. 2. Remove the automatic transaxle . (Refer to Automatic Transaxle System - "Automatic Transaxle") 3.
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Compressor Repair procedures
Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative (-) battery terminal. 3. Remove the engine room cover.
Hyundai Genesis (DH) 2013-2016 Service Manual: Console Temperature Control Actuator Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the console temperature control actuator connector. 3. Verify that the console temperature control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Description and Operation
- Electric Parking Brake (EPB) Repair procedures
- Body (Interior and Exterior)
- New on site
- Most important about car
