| Troubleshooting |
| Trouble symptom | Probable cause | Remedy |
| Hard steering | Improper front wheel alignment | Repair |
| Excessive turning resistance of lower arm ball joint | Replace |
| Flat tire | Adjust |
| No power assist | Repair or Replace |
| Poor return of steering wheel to center | Improper front wheel alignment | Repair |
| Poor ride quality | Improper front wheel alignment | Repair |
| Damaged shock absorber | Repair or Replace |
| Varied or damaged stabilizer | Replace |
| Varied or damaged coil spring | Replace |
| Worn lower arm bushing | Replace |
| Abnormal tire wear | Improper front wheel alignment | Repair |
| Improper tire inflation pressure | Adjust |
| Worn of shock absorber | Replace |
| Wandering | Improper front wheel alignment | Repair |
| Poor turning resistance of lower arm ball joint | Repair |
| Loose or worn lower arm bushing | Re-tighten or Replace |
| Vehicle pulls to one side | Improper front wheel alignment | Repair |
| Excessive turning resistance of lower arm ball joint | Replace |
| Varied or damaged coil spring | Replace |
| Bent lower arm | Replace |
| Steering wheel shimmy | Improper front wheel alignment | Repair |
| Excessive turning resistance of lower arm ball joint | Replace |
| Varied or damaged stabilizer | Replace |
| Worn lower arm bushing | Replace |
| Worn of shock absorber | Replace |
| Varied or damaged coil spring | Replace |
| Bottoming | Broken or worn spring | Replace |
| Malfunction of shock absorber | Replace |
| Wheel and tire diagnosis | ||
| Rapid wear at the center | Rapid wear at both shoulders | Wear at one shoulder |
|
|
|
Special Service Tools Tool Name / NumberIllustrationDescriptionStrut spring compressor09546-26000Compression of coil springBall joint remover09568-2J100Removal of ball jointEngine support fixture (bar)09200-3N000Removal and installation of the transaxle. Other information:Hyundai Genesis (DH) 2013-2016 Service Manual: SpecificationsS Hyundai Genesis (DH) 2013-2016 Service Manual: Heater & A/C Control Unit Repair proceduresSelf Diagnosis 1. Self-diagnosis process 2. How to read self-diagnostic code After the display panel blinks three times every 0.5 second, the corresponding fault code blinks on the setup temperature display panel every 0.5 second and will show two figures. Categories
Copyright В© 2025 www.hgenesisdh.com - 0.0208
| ||