Hyundai Genesis: General Information / Troubleshooting

Troubleshooting
Symptom
Suspect Area
Engine does not start or is hard to start
Vapor hose damaged or disconnected
EEngine struggles to start
Malfunction of the purge control solenoid valve
Rough idle or engine stalls
Vapor hose damaged or disconnected
Malfunction of the PCV valve
Rough idle
Malfunction of the evaporative emission control system
Excessive oil consumption
Positive crankcase ventilation line clogged

Specifications
Specifications Purge Control Solenoid Valve (PCSV) ? Specification ItemSpecificationCoil Resistance (?)22.0 ~ 26.0 [20°C(68°F)] Fuel Tank Pressure Sensor (FTPS) ? Type: Piezo-Resistive ...

Components and Components Location
Components Location 1. PCV Valve2. Canister3. Purge Control Solenoid Valve (PCSV)4. Fuel Tank Pressure Sensor (FTPS)5. Canister Close Valve (CCV)6. Fuel Level Sensor (FLS)7. Fuel Tank Air Filt ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Front Lower Arm Repair procedures


Replacement [4WD] Remove the lateral arm 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from the front hub. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)   & ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Rear Bumper Cover Repair procedures


Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • When removing the interior trim pieces, use a ...

© 2013-2025 www.hgenesisdh.com